Hubbell M4100b12r 100a 125-250v Inlet
SKU: 96249252079

Hubbell M4100b12r 100a 125-250v Inlet

$346.00 $384.45
Save 10%
No.2 Bestseller on intrade-apc.com >

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 8 - Jul 13

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Hubbell M4100b12r 100a 125-250v InletHubbell Marine was the first to offer 100 amp marine grade devices that are considered second to none. Hubbell developed the standard for 100 amp Pin and Sleeve devices with the National Electric Code and the American Boat and Yacht Council. Only Hubbell offers 3, 4 and 5 wire 100 amp cable sets for your shore power requirements. Cable sets manufactured in factory controlled conditions using specially compounded cable to accommodate a full 100 amp.

Hubbell Marine was the first to offer 100 amp marine grade devices that are considered second to none.

Hubbell developed the standard for 100 amp Pin and Sleeve devices with the National Electric Code and the American Boat and Yacht Council.

Only Hubbell offers 3, 4 and 5 wire 100 amp cable sets for your shore power requirements.

Cable sets manufactured in factory controlled conditions using specially compounded cable to accommodate a full 100 amp.

100 Amp pin and Rugged, watertight, sleeve devices. UL listed, AB02029 YC compliant, corrosion resistant.

100 Ampere, 125/250 Volt 3 Pole 4 Wire Ship-to-Shore Devices

M4100B12R
Gray nylon shore power inlet has gasketed, spring-loaded cover which closes automatically when not in use and is watertight when securely fastened. Mounting holes are 4.88 in. (123.8) on centers and rear portion has 3.94 in. (100.0) diameter. Mounting screws and gasket included.

M4100C12R
Yellow Zytel® super tough nylon watertight connector body has gasketed locking ring to make inlet/connector interface watertight. Cord grip range is 1.00?1.94 in. (25.4?49.3). Note: This device mates with shore power inlet only.

M4100P12
Yellow Zytel® super tough nylon watertight plug has gasketed locking ring to make plug/receptacle interface watertight. Cord grip range is 1.00?1.94 in. (25.4?49.3).

M4100R12
Gray nylon dockside receptacle has gasketed, spring-loaded cover. Closes automatically when not in use and is watertight when securely fastened. Mounting holes are 4.88 in. (123.8) on centers. Mounting screws and gasket included.

M4100C12
Yellow Zytel® super tough nylon watertight connector body for mating plug to connector interface on extension cords or adapters. Cord grip range
is 1.00?1.94 in. (25.4?49.3). Note: It cannot be mated to the shore power inlet.

100 Ampere, 3 Y 120/208 Volt and 3 Y 277/480 Volt 4 Pole 5 Wire Ship-to-Shore Devices

M5100B9R
Gray nylon shore power inlet has gasketed, spring-loaded cover which closes automatically when not in use and is watertight when securely fastened. Mounting holes are 4.88 in. (123.8) on centers and rear portion has 3.94 in. (100.0) diameter. Mounting screws and gasket included.

M5100C9R
Yellow Zytel® super tough nylon watertight connector body has gasketed locking ring to make inlet/connector interface watertight. Cord grip range is 1.00?1.94 in. (25.4?49.3). Note: This device mates with shore power inlet only.

BB1001W
15° angle cast aluminum back box has corrosion resistant gray finish and top hub with 1 in. N.P.T. 100A receptacles can be mounted directly to it.

BB100N
15° angle non-metallic back box, made of high-grade engineered thermoplastic Valox® to resist chemicals, abuse and U.V. rays. Has integral grounding plate, 1 in. N.P.T. hub size and 120 cu. in. capacity (hub is not included - Raco part number 1706 is recommended).

M5100P9
Yellow Zytel® super tough nylon watertight plug has gasketed locking ring to make plug/receptacle interface watertight. Cord grip range is 1.00?1.94 in. (25.4?49.3).

M5100R9
Gray nylon dockside receptacle has gasketed, spring-loaded cover. Closes automatically when not in use and is watertight when securely fastened. Mounting holes are 4.88 in. (123.8) on centers. Mounting screws and gasket included.

M5100C9
Yellow Zytel® super tough nylon watertight connector body for making plug to connector interface on extension cords or adapters. Cord grip range is 1.00?1.94 in. (25.4?49.3). Note: It cannot be mated to the shore power inlet.

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 96249252079

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.3 ★★★★★
Based on 1949 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
M
Verified Purchase
Mike
Houston, US
★★★★★ 5
I love it!!
Style: Dual Arms, Size: 17"-33"
I love this product. I do a lot of gaming and you tube watching. At the same time a lot. With this I keep my desktop clear so I can have my notebooks there and can still have both my monitors up and running. Another plus is if I decide to sit on the couch and play the console I can turn the screen a full 180 degrees so I can setup you tube and play games on the T.V. using the console. The product itself feels to be of decent quality. It is not all plastic. The clamp is nice and strong.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 24, 2026
E
Verified Purchase
Ezra
Houston, US
★★★★★ 3
Gets the job done. Just barely.
Style: Dual Arms, Size: 17"-33"
It holds up my monitor, but just barely, and without any confidence or finesse. I had to move on from my previous arm mounts, the HUANUO. Those claimed to hold up to a 30 inch monitor and support 20 pounds. When I upgraded to a Samsung Odyssey Neo G8, it could no longer perform its duties. The gas shock was up to task, but the final adjustment piece that tilts it up or down was a hard down. Queue this piece of hardware! 22 pounds is more than 20, and 32 is more than 30. This time I'm not even technically out of spec. The clamping force seems more than adequate to hold this to my desk. I will, at this point, basically walk you through how I feel about this mount, based on the order of installation instructions. The way it goes together means that you will have to pull your desk out to maneuver the clamp in place before snugging it back up to the wall, a point in the HUANO's favor since it had a clever leveraging mechanism that lets you hang it with your desk still against the wall. The way cords route through the arms close to the base means that you have to route them before you put the swivel arm on the base. This is because it has a screw at the front and back to secure the cover, and the angle/height are such that you cannot fit a screwdriver into the bottom one after you mount it. While not impossible to do with it installed, it would involve a right-angle screwdriver. They provide one of those, but the screwdriver bit of it is on the long shaft, and you would need it on the short shaft to get to that screw. The way the swivel arms mount on the base is less than ideal as well. The arm slips onto a robust metal hub, and you tighten a screw that pushes against a plastic tab that makes it harder or easier to move. The location for this screw faces the wall. So you must turn the arm at an extreme angle to make it tighter or looser. Not a big deal, but noticeable. Top arms go on smoothly, cable routing is simple and easy. No complaints about this section. Mounting the monitor. The instructions are to mount the plate to the monitor, and then slide the plate onto the holder and secure it with the screw. I did this for neither of my monitors, although I tried it for my second. My big monitor went smoothly by mounting the bracket ahead of time and just forcing the arm down into position while my monitor rested on my desk. I tried this for my second bracket, but it was much harder to do with the monitor in a vertical orientation. So then I tried to do it the way the instructions wanted. I would have been able to do so, but my monitor has the mounting location set into the back of the monitor. This means that you can't mount it flush and then slide it on because you don't have clearance. So I tried to use the spacers. The spacers aren't spacious enough and the screws bottomed before snugging. While I'm not saying that solution wouldn't have technically worked, I instead reverted back to mounting the bracket first. This time I laid my monitor flat on the desk, reduced the tension in the shock greatly, and placed it into position that way. At the end when it's complete and setup? It works. It will hold the G8. But just barely. The G8 uses an adapter to go from the monitor mounting points to VESA 100. This adapter sticks out quite a bit from the monitor, which means the weight is further away from the mounting point. Getting the tilt adjustment to hold involved a bigger allen wrench and cranking it further than it seems like it was meant to go. It groaned, but it held. It wants to dip if you mess with it, so I crank it again. Will it one day totally fail on me and point my monitor at my desk? Maybe. But it works on day 1, so that's a start.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 29, 2024
N
Verified Purchase
Nikki05
Charlottesville, US
★★★★★ 5
Holds Backpack Straps Together
Size: 6inches-60PCS
Good quantity for its price. It’s a good quality and durable. I use it to hold my Loungefly backpack straps that I hang on my wall and it does its job perfectly. It’s reusable too.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 22, 2026
R
Verified Purchase
Raniel Nebrida
Cuba, US
★★★★★ 5
Perfect for small normal cables lying around.
Size: 6inches-200PCS
Cable ties to organize my random cable is what I needed in my life. The quality is solid and it's easy to use and adjust. They hold well without slipping and the size is perfect for use with normal cables. its about 6 inches long so its gives you a little less than 3inch radius considering they way it is suppose to loop. I think realistically, its more like 2 inch radius. It is versatile and can be reused considering its velcro.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 6, 2026
C
Verified Purchase
CJKA
Waukegan, US
★★★★★ 5
Perfect Velcro Cable Ties for Everyday Use!
Size: 6inches-60PCS
Great value for good quality Velcro cable ties! These are perfect for your electronic organizer bag or just to organize random loose cables around the house. Hard to tell how long they'll last, but for the price, they are easily replaceable. Highly recommend!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 16, 2026

recommand products

Terra, Herald of Hope (Borderless) (204) (Foil) [FINAL FANTASY]
99.80
Thousand-Year Elixir (Borderless) (148) [Special Guests]
21.92
Terra, Herald of Hope (Borderless) (204) [FINAL FANTASY]
66.00
Skysovereign, Consul Flagship (First-Place Foil) (103) (Foil) [Special Guests]
34.90
Homeros (Rare Pull) (BT24-102 SEC) (Foil) [Time Stranger]
226.45