ICON 65053 Centerline Steering Stabilizer

GAP carries the Icon 65053 Centerline Steering Stabilizer you need for better handling performance in your 2023 Ford F-250/350 Super Duty 4WD. The ICON Centerline Steering Stabilizer features a through-shaft design to remove the push/pull sensation associated with conventional steering stabilizers. This results in more consistent damping and symmetrical steering feel throughout the steering range. The large 2.5" diameter stabilizer body and piggyback reservoir improve fluid volume to prevent performance fade due to heat and cavitation. This unit delivers a significant increase in steering damping compared to the factory equipment, for an improved driving experience with both stock and oversize aftermarket wheels and tires. The stabilizer body shares components with ICON's proven 2.5 Series shock absorbers, meaning this unit is fully rebuildable. The 2.5 Series features a 6061 hard anodized aluminum shock body for exceptional corrosion resistance and a stout 7/8" chrome-plated induction-hardened steel shaft. FK Rod End bearings provide precise function & feel throughout the input range. Installation is 100% bolt-on using common hand tools and should be an easy job for both qualified mechanics and experienced DIY'ers.

Features:

• 100% Bolt-On Installation
• Piggyback Reservoir Design
• 7/8" Chrome-Plated Induction-Hardened Steel Shaft
• Drastically Increased Steering Damping Over Stock Unit
• Fully Rebuildable ICON Vehicle Dynamics 2.5 Series Shock
• Provides Symmetrical Steering Feel Throughout Input Range
• FK Rod End Bearings For Precise Function & Feel Throughout Steering Range
• 6061 Hard Anodized Aluminum Shock Body Provides Excellent Corrosion Resistance
• 5WT Shock Oil For Consistent Suspension Damping Along A Wide Temperature Range
• Through Shaft Design Eliminates The Push/Pull Sensation Associated With Traditional Stabilizers

Note:
Only compatible with 4WD models.
Not compatible with aftermarket tie rods.
Mounts over stock front differential cover, not compatible with most aftermarket covers.
After installation, cycle steering left and right to ensure the full range of steering is achievable and the stabilizer is installed correctly.
Use ICON 1" front bump stop spacers, part # 61112, unless the suspension system that you are using calls for larger bump stop spacers. If using a non-ICON configuration, cycle the suspension to verify that the stabilizer does not make contact upon full compression.