Pay in installments of $3.75 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 17 - Jul 22
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Sarracenia, 3.5in, Rubra ssp. GulfensisSarracenia rubra ssp. gulfensis is the name, coined by sarracenia expert Don Schnell, for this beautiful pitcher plant. The dense clumps of narrow green pitchers are streaked with red toward the opening, with a red flush around the hood. They are often the last of the pitcher plant to go dormant, looking stunning well into fall. In spring, they will produce fragrant, rosy red blooms. If you need any more photos or additional information on this
Sarracenia rubra ssp. gulfensis is the name, coined by sarracenia expert Don Schnell, for this beautiful pitcher plant. The dense clumps of narrow green pitchers are streaked with red toward the opening, with a red flush around the hood. They are often the last of the pitcher plant to go dormant, looking stunning well into fall. In spring, they will produce fragrant, rosy red blooms.
If you need any more photos or additional information on this product, send us a message using the chat button on our website with the product name, and we will get back to you as soon as possible.
This plant has a representative product photo and the item you will receive may not be exactly as shown.
Attributes
Type: Carnivorous, Tropical, HouseplantHeight: 8 in - 12 in
Spread: 6 in - 8in
Light:Full to Partial Sun
Water: Moderate, Purified
Zone: 6-8
Pet Safe: Non Toxic
Care
General Maintenance: Be careful with your pitcher plant, they are sensitive to rough touch. Feed with a few live or dead insects once every couple of weeksTemperature:-5 degrees Celcius to 28 degrees Celcius, it is best to not let them freeze, the pitchers may die but the rhimozone should survive short amount of time frozen
Light:These plants will thrive outdoors in the warm season in full sun. Bring indoors for a dormancy period. Bright indirect light will work as well, but they are best suited to outdoor locations
Watering: Water only with the purest water you have available. Rainwater or reverse osmosis water are best. If using bottled water, make sure there is no salt. If using tap water, allow to sit for a minimum of 24 hours to evaporate any chlorine and sterilizing agents.
Soil:Open, wet and boggy, but can tolerate more sandy soil. Main thing with any carnivorous plant is to give them the poorest soil possible. They will thrive in a mixture of pebbles and peat moss. Avoid rich soil and clay.
Fertilizer: To fertilize any carnivorous plant, you feed them insects. With pitcher plants just drop live or dead insects into the pitchers. DO NOT FERTILIZE THE SOIL this will cause chemical burns and kill your plant.
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.5 ★★★★★
Based on 13 reviews
Sort
Product Reviews
★★★★★ 5
Superior Design!
Size: 6 Pairs / 12 pcs
Delivery was lightning fast.
I tried a pack of two pairs of these banana jacks as a sample to see if these would meet my needs. The design of these plugs is superior. The design was exactly what I wanted because the speaker wire is secured with TWO set screws. Then I ordered an additional six pairs of plugs to hook up my subwoofer to my amp and speakers.
(I feed the audio output from the amp to the sub. The sub has a crossover that keeps the low frequencies and sends the mid and treble frequencies to my bookshelf speakers.)
I love the security of two set screws on each plug and love the barrel that screws on AFTER the wire is secured by the set screws. Most banana plugs have a hole through the shaft of the plug that receives the stripped wire. Then the barrel cover is screwed down to secure the wire in the plug. This design compresses the speaker wire but eventually the cap loses it grip and allows the connection between the wire and the plug to become loose. Then the transfer of the audio signal becomes poor and the speakers sound bad. Every month or two I needed to check all the banana plugs and re-tighten many of them for the best performance. The two set screws eliminate this problem. The set screws are quite small and take a little extra care in installation. You will need a small flat blade screwdriver to tighten them. I used the 1/8" flat blade driver from a set of jewelers screwdrivers.
These well made plugs are a bit pricier that many of the banana plugs available but certainly not the priciest plugs available. For me, the slightly higher price was more than offset by the security of the wire within the plug.
I'm not thrilled with the extra tight fit of the tip on the plugs into the jacks. It took a lot of effort to insert the in the jack. Actually I "greased" the pins (very sparingly) with with non-corrosion, conductive paste (Ox-Gard, No-Corrode, etc. Do NOT use any other grease.) Next time I'll use pliers to compress the pin.
My only quibbles are that the spring pins that go into the jack are very tight and that the plugs are only sold in quantities of two pairs or 12 pairs.
I recommend these banana plugs for all who are using the banana plugs and jacks for hooking up your speakers. It's a very convenient way of connecting speakers if your speakers and amplifier have the banana jack as part of the binding post. Further, it's much safer to use banana plugs since the possibility of shorting your amplifier with a stray strand of wire is practically zero. Easy Five Stars.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 13, 2018
★★★★★ 5
Top banana
Size: 5 Pairs / 10 pcs
Theses banana plugs are hight quality non magnetic. Banana plugs easy to usexand very high quality sound different because of the better connection and quality.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 24, 2026
★★★★★ 5
Very easy to use
Size: 12 Pairs / 24 pcs
I have an Onkyo audio/video receiver along with an Emotiva amplifier. Both have speaker "post" terminals which will accept banana plugs, OR I can connect the speaker wires by unscrewing the posts, poke the speaker wires into the terminals and then tighten the posts. The problem with poking the wires into the terminals and tightening the posts vs using banana plugs is that there is a risk of the wires touching the metal on the back of the chassis or touching other speaker wires, causing a short if one is not careful. With banana plugs, they simply plug into the back/top of the posts, eliminating the rsick of a short circuit. They can also be unplugged very easily if needed. Banana plugs are DEFINITELY the preferred way to connect speakers to an receiver or amplifier if they have post-style terminals.
These particular banana plugs came in a package of 12 I believe. They were very reasonably priced, and simple to connect to the end of the speaker wires. Simply unscrew the banana plugs, use a small, standard jewelry screwdriver and loosen both of the set screws, insert the speaker wire, then tighten the set screws, and then screw the banana plug back together.
The plugs have either a red band which would typically be used for your "Right" speakers, or a black band which would typically be used for the "left" speakers. The banana plugs insert into the top or front of the speaker terminal posts on the amp and receiver. They fit VERY snug, and so I did have to apply just a little bit of pressure in order to insert them into the posts, but once plugged in, rest assured they're not going anywhere. They are snug.
I highly recommend these.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 2, 2025
★★★★★ 5
Flexible PVC Cable
Size: 2 Gauge 10FT
If you like the slick, shiny surface of PVC but want the flexibility of welding cable, this is a pretty good option. Easy to shape and makes solid crimps. One of my favorites.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 28, 2026
★★★★★ 5
Good quality for a good price!
Size: 6 Gauge 15FT, Size: 6 Gauge 15FT
Good value for the quality of these copper cables. Cut them to the length I needed and put a copper eyelet on one end. Wire size works good between my Victron solar charge controller and the batteries. Wire gauge will be able to handle the wattage much better than what I was using. They look much more professional than the old cables I was using also!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 15, 2025