Blackmagic Design Spares - Camera PCC6K - Service Kit

The Blackmagic Design Spares - Pocket Cinema Camera 6K (PCC6K) - Service Kit is a maintenance package designed for the original, non-tilting screen version of the Pocket 6K. Since this camera is often used in rigged environments (cages, gimbals, and drones), certain external parts are prone to stripping, snapping, or going missing.

This kit provides the "sacrificial" parts needed to keep the camera body sealed and structurally sound.

What is Included in the Kit?

Unlike the "Pro" kit, which includes ND seals and tilting hinges, the standard 6K kit focuses on the core chassis and ports:

• Rubber Port Cover Set: A full replacement for the left-side interface flaps (Full-size HDMI, USB-C, 2-pin Power, Mini XLR, and 3.5mm Jacks).

• Battery Door Assembly: The LP-E6 battery door, including the metal hinge pin and the tension spring.

• Complete Screw Set: All external Torx and Philips screws for the carbon fiber polycarbonate body. These include the specialized "stepped" screws used for the chassis seams.

• 1/4"-20 Threaded Inserts: Replacement brass/steel bushings for the top and bottom mounting points.

• Bottom Cover Gasket: The environmental seal that sits between the main body and the bottom plate.

When to Use This Kit

• Environmental Protection: If your port covers have torn off, the internal Main PCB is vulnerable to humidity and dust. Replacing these is the most effective way to prevent long-term corrosion.

• Rigging Damage: If you have over-tightened a tripod plate or top handle and the threads have "spun" or stripped, you will need to replace the internal threaded inserts provided in this kit.

• Lost Fasteners: After a year of heavy vibration on car mounts or gimbals, it is common for the small chassis screws to vibrate loose. This kit ensures you have the exact OEM replacements.

• Battery Power Issues: If your battery door doesn't latch securely, the LP-E6 battery can shift, causing the camera to lose power mid-take.

Key Differences: 6K vs. 6K Pro Service Kits

It is vital to ensure you have the correct kit for your specific model:

• Battery Door: The standard 6K kit uses the LP-E6 door (smaller), while the Pro uses the NP-F570 door (larger).

• Port Layout: While the ports are similar, the physical molding of the rubber flaps differs between the original 6K and the 6K Pro/G2 bodies.

• Screen Parts: The standard 6K service kit does not include hinge parts, as the screen on this model is fixed.

Technical Installation Note

• Adhesive Cleanup: When replacing the rubber port covers, use a Q-tip with a small amount of Isopropyl Alcohol to clean the "plug" holes. If there is old dirt or adhesive in the holes, the new covers will not stay seated.

• Screw Torque: The 6K body is a carbon fiber composite, not metal. Do not over-tighten the screws. You should stop as soon as the screw head meets the body, then give it a "tiny" fraction of a turn. Over-tightening will crack the plastic screw bosses.

• Battery Door Spring: When installing the new door, pay close attention to the orientation of the small torsion spring. If installed backward, the door will not "pop" open when the latch is pulled.

Expert Advice: If you are missing screws, do not replace them with random hardware store screws. The 6K uses specific lengths; a screw that is even 2mm too long can pierce the internal Main PCB or the Sensor Flex Cable when tightened down.

Are you looking to refresh the look of the camera for resale, or have you experienced a mechanical failure like a stripped mounting thread?